Reconnect power to washer plug in.
Maytag 3000 washer locked with door open.
Remove the screws coming in from the back of the top panel.
The door will not immediately unlock while the cycle is running due to a possible high water level in the washer high water temperature tumbling or spinning.
The door should unlock after 60 seconds.
The door lock led light will blink.
If not call for service.
The door may immediately unlock.
The washer will go into a hold and drain routine for 8 minutes.
If there is no motor humming pull the washer forward and unplug it.
You should then be able to open the washer door.
This is a page about unlocking the door on a maytag front load washer.
After 15 minutes it will reset and the motor will stop humming and the door will unlock.
Run a drain and spin cycle.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
The top panel will pull straight back up and off.
Wait approximately 2 minutes for control to reset.
Inspect the door lock for damage.
You will hear the door click when it unlocks.
If the door lock is defective the washer door will not latch properly.
The door lock secures the washer door shut during operation.
The door should unlock after this is complete.
Gently pull the tab down about a 1 4 or until a click is heard.
Manually unlocking the door lock system 1.
Door on the maytag 3000 series front load washer will not open after placing clothes in the washer shutting the door and pressing the start button a buzzing sound starts and then an f22 code comes up.
Remove the lower kick panel.
It may take up to five minutes for the washer to stop spinning and draining before the door will unlock.
If the door lock is damaged or does not latch properly replace it.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Door on the maytag 3000 series front load washer will not open after placing clothes in the washer shutting the door and pressing the start button a buzzing sound starts and then an f22 code comes up.
After plugging the washer in one of the following 3 events will happen.
Reach up along the inside of the front and locate the bottom of the door switch lock unit.
Unplug washer or disconnect power.
The door lock can fail either mechanically or electrically.
Located on the bottom of the door switch lock unit is a teardrop shaped tab.
Nothing else will appear to be happening with the machine during this time.
